Over time I going to add more and more diagrams to get to the end of the course.I will be give photos how to set up when i dont going to give photos i going to describe how to set up this.


When you finish cut all parts you have to put No4 on the No3 First No4 80mm from back of No3 Second No4 180mm on the front of No3 you have to put this using angle and screws After we need to screw No5 to No3 its to hold MCP Panel you need to calculate Middle of your glare shield ( IF you using my diagrams is 745mm) After you need to calculate MCP Long my is 46cm long i 23cm for left and 23cm for right (dont understand ? Contact Via mail olbi123@googlemail.com)
After you need with your hand put No1 and No2 on the No4, using pencil get position of screws .
After Drill holes on it, Screw it hard.
After finish its has to look like this(After i going to add photos from under case)

I Forogt in my photo i have other No3 but i going to change it in some time.
O i forogt about angles in No4 angel is 8deegrees.


Will be continue...

Yours Maciek.